Jul 1, 2022 · I wanted a valve on the main line and a plumber installed a shark bite valve Now, 6 years later, I find that the fitting is spinning. It might have been spinning earlier as well and I did not realize …

May 30, 2020 · On another thread, a pro maintenance plumber says he always uses Sharkbite for repairs and they'll last as long as copper fitting repairs. While I'm old school enough to wonder about …

Jan 9, 2022 · I want to use a 1 inch sharkbite elbow to receive a 1 inch copper pipe coming down from a hot water cast iron radiator. I want to do this because the floor...

Feb 28, 2025 · 1. Is it okay to use a sharkbite immediately off the incoming line before the main shutoff like I am planning, or should this always be soldered? 2. If the answer to 1 is soldered, should I …

Jul 29, 2020 · If there is still solder on the copper will Sharkbite connector still work. I may need to cut the pipe with a dremel or hacksaw then find a way to deburr/smooth the outside edge.

Nov 11, 2009 · Is there any qualitative difference in long-term reliability and general likelihood of good outcomes by inexperienced users between Sharkbite and removable-type Gatorbite fittings? I've …

Nov 20, 2008 · I've got a couple shark bite caps on hot and cold water copper supply lines that I'm ready to remove and replace with valves (plumber put them on). I thought it would be a simple matter of …

Feb 23, 2012 · Sharkbite fittings are like any other press lock fittings that employed o-rings and water pressure to seal. However, if I recall correctly o-ring have life expectancy of 15 years or more …

Nov 20, 2013 · A 1/2" Sharkbite needs about an inch of pipe to seat fully if I remember (it says on the package and varies by the diameter of the fitting). A compression fitting also needs a moderate …

Mar 14, 2021 · DIY'er here. I understand that I can use a Sharkbite connector on PEX-B, but can I use them on PEX-A as well? I am converting from copper to PEX-A in the crawlspace and don't have the …